Specifications

8 HDS4.1 Component Video Switch
1 2 3 4
ZEKTOR
Step 1: Place the HDS4.1 into the Setup Mode
Press and hold the Power Button for 4 secs.
The standby LED will blink wildly, and the
selection LEDs will start sequencing to the
right.
Step 2: Select “Lighting Mode” option
1 2 3 4
ZEKTOR
After ‘3’ is pressed, the standby
LED continues to fl ash, and the
front panel will display the cur-
rent Light Mode setting.
Step 3: Choose a new lighting mode
1 2 3 4
ZEKTOR
Auto-Fade
Always Bright
Always Dim
Always Off
Exit Setup Mode
13HDS4.1 Component Video Switch
Setting the Initial Power On State
As long as the HDS4.1 is plugged in, it will remember the previously
selected input in standby mode. When powered up by pressing the
Power button, it will return to that previously selected channel.
However, if power is removed (for instance a plug strip used to
power the HDS4.1 is turned off), and then re-applied, the HDS4.1’s
default behavior is to enter into the standby mode.
It is possible to change the power on behavior of the HDS4.1.
To change the power on defaults...
Step 1: Setup the HDS4.1 to your preferred power on state
.
Use the front panel buttons to setup the HDS4.1 to the op-
erating settings you’d like at initial power up.
Step 2: Save the new initial power on state.
First press and hold the Power button.
While continuing to hold the Power button, press and hold
the ‘1’ button.
After holding both buttons for about ‘4’ seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
You can test the new defaults by either disconnecting the
power supply from the back of the HDS4.1 or by unplug-
ging the power supply from the wall.
Reconnect power. The HDS4.1 will power up into your new
power on default state.
• 1. 2. 3. • •