Owner`s manual

Using Different Remote Codes

Using Alternate Component Keys on your Remote

The HDS4.2 will also respond to alternate component key codes. Allowing you to use an unused

TV, VCR, RCVR or one of the added AUX positions many remotes include.

Setting up the HDS4.2 to respond to alternate component codes is a two step process. You must

first program your universal remote control to behave as one of the alternate components. You must

then teach the HDS4.2 to respond to the alternate component codes.

Programming your remote to different components

The HDS4.2 will respond to eight different pre-programmed component codes, they are: Yamaha

VCR, Hitachi Satellite, Sony TV, Go Video VCR, Awia DVD, Nakamichi Receiver, Jerrold Cable Box

and a Symphonic TV. The following table shows the different component buttons and codes used

to program a few different universal remotes.

If your remote control’s model matches one of the above, read your remote’s user manual for in-

structions on programming your remote control, then use the above device and manufacturer codes

to setup your remote.

If your remote is not included above list, or the manufacturer code given does not work, then you

will have to follow your remote controls instructions for programming one of the above components

and search for a proper match. See the next section. Or teach the HDS4.2 a new set of codes, See:

"Learning New Remote Codes" on page 9.

Teaching the HDS4.2 a new component code

After your remote control has been programmed to act like one of the 8 built in code-sets, teaching

the HDS4.2 to use the new code set is simple.

Make Device Sony

One For

All

Sanyo RCA Zenith X10

Yamaha VCR 040 0038 238 009 025 022

Symphonic TV 023 0171 104 189 520 202

Sony TV 001 0000 110 002 708 015

Hatachi SAT N/A 0819 N/A 084 N/A N/A

Go Video VCR N/A 0432 248 138 139 013

Awia DVD 015 0641 N/A 350 N/A N/A

Nakamichi RCVR 086 N/A N/A N/A N/A N/A

Jerrold CBL 001 0476 303 046 552 062