Owner`s manual

6
Programming your Remote Control
Setting up your Universal Remote Control
For remote control operations, the HDS4.2 requires either a Universal Remote control to be pro-
grammed as one of eight pre-programmed devices, or alternatively, the HDS4.2 can be taught to
use most existing remote controls.
The simplest way to begin using the HDS4.2, is to program your Universal Remote control to act
like the remote used to control a Yamaha VCR. Once this is done you will be able to immediately
start using your HDS4.2.
Check your remote’s user manual for instructions on programming your remote control.
The following table shows the Yamaha VCR codes for a few different brands of Universal Remote
Controllers:
Make Device Code
Sony VCR 040
One For All VCR 0038
Sanyo VCR 238
GE / RCA VCR 009
X10 VCR 022
Zenith / Phillips /
Magnavox
VCR 025