Specifications

28 HDMI5 Component Video Switch
29HDMI5 Component Video Switch
Auxiliary Relay Options
The t wo g enera l pu rpo se a uxil iar y relays are rate d at 30 vo lts A.C.
or D. C. @ 5 a mps, and can be u sed to cont rol a ny thin g wi thin tho se
limi ts.
There are 4 differe nt op erati ng m odes of the Rel ay s:
Mode 1 - Toggle
The re lay to ggle s ea ch t ime the re lay's but ton i s pre ssed. Th i s i s th e
simp lest , an d fa cto r y d efau lt, mode of operat ion.
Mode 2 - Momentary
Each relay can be s etup to stay o n a program med amou nt o f ti me,
and then tur n o ff, e ach time the relay' s bu tton is p resse d.
Mode 3 - Channel Controlled - Steady State
The re lays c an b e se tup to tu rn o n ea ch t ime spec ifie d ch anne ls a re
sele cte d. By sel ec ting all cha nnel s, the relay wil l tu rn o n ea ch t ime
the HDMI 5 is power on, and tur n of f wh en t he H DMI5 is tur ned off.
Mode 4 - Channel Controlled - Momentary
The re lays c an b e se tup to tu rn o n for a pro gramme d am ount tim e
each tim e sp ecif ied chan nels are sele cte d, and the n tu rn off.
Entering the Relay Setup Mode:
Place the HDMI5 into the Setup Mode
Pres s an d ho ld t he Power to ente r S etup Mo de.
Select Relay to Setup (A1 or A2)
Chos e th e rel ay to setu p by pressi ng A 1 or A2.
Relay Setup Overview
See ill ustra tion for a n over v iew of t he R elay Set up M ode.
The followi ng pa ges d escri be the s ettings for e ach o f the dif-
ferent rela y modes...
1 2 3 4 5 SEL A1 A2
Place the HDMI5 into the Setup Mode
Press and hold the Power Button until the
display goes wild. (About 4 seconds.)
1 2 3 4 5 SEL A1 A2
Select Relay to Setup (A1 or A2)
Select a relay to setup by pressing either A1 or A2
Relay Setup Overview
1 2 3 4 5 SEL A1 A2
If the red LED is lit, then the relay activates when
channel is selected. Use buttons to toggle LEDs.
The blue LED indicates Steady-State, the red LED
indicates Momentary. Use button to toggle LEDs.
The blue LEDs indicate delay times.
A1 = Decrease delay
A2 = Increase delay
Press Pwr Button to
exit setup mode.