Specifications

16 HDMI5 Component Video Switch
17HDMI5 Component Video Switch
1 2 3 4 5 SEL A1 A2
Step 4: Select between Bright and Dim settings: Use SEL button.
Step 5: Adjust Front Intensities.
1 2 3 4 5 SEL A1 A2
Use A1 and A2 to dim and brighten LEDs
A1 = Dim LEDs.
A2 = Brighten LEDs.
Adjusting the Front Panel Intensity
Continued from previous page...
If you h ave not alre ady done so, pe r form Step s 1 and 2 on the previ -
ous page.
Step 4: Toggle between Bright and Dim Settings
The ' SEL' LED indi cates the front pan el i ntensi ty set ting s:
If BLUE LED is l it, then the BRI GHT level is bein g ad juste d.
If RED LED is l it, then the DIM leve l is bei ng a djus ted.
Use t he ' SEL' butt on to togg le b etwe en b righ t an d di m
sett ings.
Step 5: Adjust Front Panel Intensities
Use t he ‘A1 ’ b utton to d ecrea se t he i ntensi ty of the front
pane l li ghts.
Use t he ‘A2 ’ b utton to i ncrea se t he i ntensi ty of the front
pane l li ghts.
Yo u ca nnot mak e th e DI M le vel b rig hter t han the BRIG HT
level, and you c anno t ma ke t he B RIGH T le ve l di mmer tha n
the DIM level.
Step 6: Use the Power Button to Exit
Once the front pane l in tensi ties are a ccept able, press the
Power butto n to save t he n ew s etti ngs and exit the set up
mode.
Note: The n ew inte nsit y s etti ngs are s aved in non- vo latil e
memo r y an d are not affec te d by a power fail ure.
•
•
•
•
•
•
Use the SEL button to toggle between
the BRIGHT and DIM settings.
1 2 3 4 5 SEL A1 A2
Step 6: Use the Power Button to Exit.
When things look good, press the
power button to exit the setup mode.