Technical data

70 Description
G-30-1682-en OPMI® Lumera® T Issue 4.0
Printed on 02. 02. 2009
The integrated assistant's microscope comprises the following
components:
18 Clamping screw for locking the coobservation tube in position
within the 12° range of rotation. After adjusting the assistant's micro-
scope as required, secure it in position using this screw. Firmly tighten
the clamping screw by hand.
19 Coobservation tube
– Invertertube for the assistant (standard)
20 Knob for setting the interpupillary distance (54 mm to 76 mm)
The correct position has been reached when the two eyepiece images
merge into one.
21 Inverter selection knob
The inverter can be turned about 360° and snaps in at the two defined
positions.
22 Focusing knob
for focusing the assistant's microscope independently of the main sur-
geon.
23 Manual magnification changer
24 Clamping screw for locking the tilt position
of the integrated assistant's microscope within the 15° tilt range. After
tilting the integrated assistant's microscope as required, secure it in
position using this screw. Firmly tighten the clamping screw by hand.
25 Clamping screw for locking the assistant's microscope in position
After adjusting the assistant's microscope as required, secure it in po-
sition using this screw. Firmly tighten the clamping screw by hand.