Technical data

236 Care and maintenance
G-30-1682-en OPMI® Lumera® T Issue 4.0
Printed on 02. 02. 2009
Balancing the monitor arm
If the TFT monitor does not remain in place in every position required, the
following readjustments can be performed.
Increasing the friction of left/right movement of the carrier arm
• Slightly tighten screw (1) of the monitor carrier arm by turning it clock-
wise using an M5 hex key.
Increasing the friction of left/right movement of the suspension arm
• Remove plastic cover (2) on the suspension arm joint.
• Loosen securing screw (4) on the carrier arm by turning it counter-
clockwise using an M2.5 hex key.
• Tighten adjustment screw (3) of the suspension arm by turning it
clockwise until the required friction has been obtained.
• Firmly retighten securing screw (4) on the carrier arm by turning it
clockwise using an M2.5 hex key.
• Reattach plastic cover (2).
Readjusting the gas pressure spring
• For correct adjustment of the gas pressure spring, align the carrier and
suspension arms in a horizontal position.
• Tighten setting screw (5) of the gas pressure spring by turning it coun-
terclockwise with an M5 hex key until the suspension arm with the
TFT monitor no longer moves downward by itself.
Note:
If the suspension arm with the TFT monitor continues to move down-
ward, the gas pressure spring is defective.
• Please contact our service department in this case.
Adjusting the friction of the TFT monitor's movement at the ball joint
• Tighten all of the four securing screws (6) of the ball joint by turning
them clockwise until the TFT monitor remains in the required position.