Technical data

210 What to do in the event of malfunctions
G-30-1682-en OPMI® Lumera® T Issue 4.0
Printed on 02. 02. 2009
Switching to the backup lamp
• Turn off the suspension system at the power switch before switching
to the backup lamp.
The lamp module contains two xenon lamps. The second lamp is used as
a backup lamp which can be swung into the illumination beam path when
the first lamp fails.
If the first xenon lamp fails, you can open lamp module (2) as follows:
• Press button (4). The lamp module is slightly ejected.
• Pull out the lamp module as far as it will go.
• Turn knob (1) through 180° until it snaps in. This swings the second
xenon lamp (backup lamp) into the beam path.
• Push the lamp module all the way back into the lamp housing.
• Reset the service hour counter to "0". Use a pointed object and press
it into the recess of reset button (3).
• Turn the suspension system back on at the power switch.
Note
:
If the first lamp has failed and the backup lamp is in use (red segment in
knob (1) lights up), make sure to have a backup lamp module ready at
hand as a precaution.