Technical data

196 Operation
G-30-1682-en OPMI® Lumera® T Issue 4.0
Printed on 02. 02. 2009
OPMI: Assigning a function to buttons C and D of the foot control
panel
Buttons C and D of the foot control panel can be configured as required.
In configuration mode 1, the upper and middle display and key fields
permit you to assign one of the following functions to buttons C and D:
The functions are explained in detail in the following.
FOOT LEFT C:
Use the upper section of the display and key field (FOOT LEFT C:) to as-
sign one of the possible functions to key C of the foot control panel.
FOOT RIGHT D:
Use the middle section of the display and key field (FOOT RIGHT D:) to
assign one of the possible functions to key D of the foot control panel.
Display Function of button C or D of the foot control panel
XY-RES RESET of XY (recentering) and focus
XYZ-RES Recentering of XY, reset of focus and zoom
FOC-
MEM
Focus memory pressed for < 2 sec:
pressed for > 2 sec:
triggers positioning
saves position
XY-INV Inversion of direction of X-Y coupling on foot control panel
SDI Triggering of SDI switchover
PHOTO Camera release at the camera interface
AUX Triggering of an AUX signal at the AUX interface (see remote
control socket on the suspension system's connector panel).
Path: After you have switched on the instrument, the basic mode is auto-
matically displayed.
To access configuration mode 1 from the basic mode, simultane-
ously press the "MODE" and "STORE" keys.
C
D
Configuration
mode 1
MODE
STORE MANUAL
FOOT
LEFT C:
PHOTO
FOOT
RIGHT D:
PHOTO
SPEED
FUNCT:
HIGH