Technical data

146 Preparations
G-30-1682-en OPMI® Lumera® T Issue 4.0
Printed on 02. 02. 2009
• Hook coupling (12) with the attached surgical microscope from above
into receptacle (11) on the suspension arm, and tilt the coupling down-
ward into its vertical position.
• Firmly tighten securing screw (3) using a 5 mm hex key.
• Insert cable clip (10) into opening (13) of the coupling.
• Release the horizontal lock by loosening locking knob (1).
• Then perform the balance setting procedure.
Warning!
Before every use and after re-equipping the system, make sure that se-
curing screws (3), (4) and (7) are firmly tightened!