Manual

In
Place
again
trans
Press
direc
posit
R
Follo
for th
arrow
A
The Z
ment
screw
Use t
Place
error
towa
A pro
when
(1 div
Note
shoo
Point
(the w
Point
(the w
Point
(the w
Point
(the w
602950_ZEISS
Operation
Press the function button (Fig. 2/B) briefly once to switch the Z-Point on.
When you switch on, the brightness of the red target dot is automatically
adjusted to suit the ambient brightness.
Automatic brightness control
The Z-Point automatically adjusts the brightness of its target dot as light
conditions change. However, the user can adjust the brightness to suit his/her
individual requirements.
Manual brightness control
The brightness of the target dot can be adjusted to suit individual require-
ments by using the function button.
The function button is under the Zeiss logo (Fig. 2/B) and operates a number
of functions:
X Press the function button briefly
O Press the function button until the required function or dot brightness is
reached (about 1 second for function number 2)
No. Function Button operation
1ON X
2 OFF O
3 Brighter XO
4 Dimmer XXO
Note: To be sure that the control system operates properly, make certain that
the sensor (Fig. 1/C) is not covered.
Installation
The Z-Point is mounted on a Picantinny rail (MIL-STD 1913) or a Weaver rail.
Clamp
The Z-Point is fitted with a patented spring clamp. It can therefore be mounted
on the rail without the use of tools.
602950_ZEISS_GBH 02 Victory_Z-Point_Innen/S. 6/Cyan = Pantone Reflex Blue/Schwarz
Instructions for use Vict
02 Vict_Z-Point_innen_pan.qxd4 03.01.2007 15:47 Uhr Seite