Operation Manual

3D Microscopy
Axiovert 100/135/135 M Eypiece and monitor version
B 40-022-4 e 09/98 31
4.2 Observation
This is a combination of the eyepiece and the
monitor version. The image is 3-dimensional
when you look through the eyepiece or on the
monitor.
4.2.1 Eyepiece observation
Set the beam path to observation on the
stand
Set the
3D VIS
mode via the rotary switch
of the 3D-CONTROL DAS-3 control unit
Place the required object on the stage,
focus on it, set Köhler illumination and
adjust the
aperture diaphragm until optimum 3D
contrast is achieved;
the image appears 3-dimensional through
the eyepiece
4.2.2 Monitor observation
Switch beam path to Camera/TV on the
stand
Set the
3D VIDEO
mode via the rotary
switch of the 3D-CONTROL DAS-3 control
unit
Place the required object on the stage and
focus on it;
the image on the monitor is 2-dimensional
first
If the image is reversed, turn the camera
around 180°
Wear polarizing glasses;
the image on the monitor is 3-dimensional
Use a familiar object to check whether the
image is upright;
if the image is not upright, switch to
Scope
LCD
in the
RESET MENU
of the MCU II
control unit
Focus depending on the object;
adjust aperture diaphragm until optimum
3D contrast is achieved