Technical data

Installation of the AxioCam MRc5
AxioCam MRc5 Installation + Reference 27
Under Windows 2000 Professional this dialog window will be displayed during
installation of the AxioCam MRc5.
Click Yes to continue the installation.
Under Windows XP Professional the Hardware Installation dialog window is
displayed. In this window click on Continue Installation.
Once the AxioCam MRc5 driver has been installed, the installation program
checks the camera’s firmware. If the firmware needs to be updated, a
message to this effect is displayed by the installation program.
Click on OK to start updating the firmware. This procedure may take a few
minutes.
While the firmware is being updated, under no circumstances
must the power supply or the data connection to the AxioCam
MRc5 be cut off. This would result in the incorrect functioning of
the AxioCam MRc5. If this situation nevertheless arises, please read
the section "Resetting the AxioCam MRc5 firmware".
The system prompts for a restart, depending on the used operating system.
After the restart the installed driver will be activated.