Technical data

Installation
Axiocam 105 color Installation + Reference Guide 7
Power is supplied to the Axiocam 105 color via the interface card. If you
switch off the PC, the camera is also switched off.
During operation the camera may heat up. This is quite safe.
Mounting the camera onto the microscope
To mount the camera onto your microscope’s TV port, use a C-mount
adapter.
Suitable adapters (example):
Port 44
Port 60
Port 60N
1.0x
452995 (44 C2/3")
456105 (60 C2/3")
426114 (60N C2/3")
0.63x
452997 (44 C2/3")
1069-414 (60 C2/3")
426113 (60N C2/3")
0.5x
452998 (44 C1/2”)
1069-415 (60 C1/2”)
426112 (60N C2/3")
The adapters are not supplied with the camera.
To mount the camera onto the microscope, remove the dust cap from the
camera’s C-mount port. Screw the adapter in as far as it will go. Then
mount the camera onto the microscope’s TV port. Please ensure that no
dust enters the opening of the camera or the microscope’s TV port.
Never touch the surface of the infrared barrier filter in front of the
CMOS sensor with your fingers. If you remove the camera from
the microscope, make sure you immediately cover the C-mount
opening with the dust cap provided, to prevent dust from getting
in.
Function Indicator
After you have switched on the PC, the LED on the camera will light up red.
As a rule, if the LED is red, this indicates that power is being properly
supplied to the Axiocam 105 color via the data cable. However the driver
has not yet been installed.