User guide

1 ProofMate™ (ProofReady) Plugin for HP Printers
48 AG50241 Rev. 4
Job output for "job name", filename "full path name of output
file", finished on <date> <time>
This message informs you that the RIP has finished creating an output file. The
job name and the full path name of the output file are specified in quotation
marks, followed by the date and time at which the output file was closed.
Printer communication failed ( error details )
Unable to connect to printer ( error details )
The text and numbers in parentheses varies, depending on the reason why the
RIP cannot connect to the printer. The final number is the error code generated
by the operating system and can be used to determine the exact cause of the con-
nection failure.
Unable to open output (error details)
Open error (error details)
This message may appear with a variety of text and numbers replacing error
details. The text varies according to the method of output that you choose in the
Configuration dialog box and the exact problem. This text should help you diag-
nose the problem. The final number is the error code generated by the operating
system and can be used to determine the exact cause of the connection failure.
Unable to create file - "full path name of output file"
This message informs you that the RIP was unable to create an output file. The
full path name of the file that it tried to create is specified within the quotation
marks. Check that the file does not already exist and that the output folder is not
read-only. You must also ensure that enough disk space is available.
Unable to create file using path "full path name of output file"
and template "file name template"
This message informs you that the RIP was unable to create an output file due to
a problem with the file path of the output file and the file name template. Check
that all the specified directories in the full path name exist and are writeable. If
an earlier error message indicates that an invalid file name template was speci-
fied, you must enter a valid file name template in the Configure Device dialog
box.