User's Manual

Pairing

Switch on and pair one drone and remote control at a time.

1. Turn on the drone. The drone's LEDs ash.

2. Place the drone on level ground.

3. Turn on the remote control. The remote control's LED ashes.

4. Move the throttle all the way up and then down to pair the

remote control with the drone. The drone’s propellers remain

still during pairing. When paired, the LEDs on both the remote

control and drone light steadily.

Note: If pairing fails, turn o the drone and remote control and repeat

the steps above, or change locations to avoid interference.

Fly Your Drone

1. After pairing, push the steering control in to switch between high

speed (double beep) and low speed (single beep).

2. With the drone on the ground, move the throttle forward to

ascend. To avoid turbulence, y the drone at least 1 ft. (30cm) o

the ground.

For advanced users: Hold the remote control with one hand,

resting your thumb on the throttle. Throw the drone about 9 ft.

(3m) away from you, and move the throttle forward to y. The

drone adjusts itself automatically and ies smoothly.

IMPORTANT: If your drone lands upside down, pull the throttle all the

way down. Wait for the propellers to stop before touching the drone.

Trim Your Drone

Move the throttle forward and see how the drone reacts.

Reverse/ Forward Movement Trim: If the drone tends

to move forward, press

; if it tends to move backward,

press

Left/Right Slide Trim: If the drone tends to slide right,

press

; if it tends to slide left, press

Note: The remote control beeps when you press a trim control, but

stops beeping when you reach maximum trim adjustment.

6001381_PM_En.indd 8 8/13/2015 5:00:38 PM