User's Manual

3. To install the battery, plug the two ends of the

white battery connectors.They only t one way,

so do not use force. Neatly slot the battery and

cables into the drone's battery compartment.

CAUTION:

• After playing, let the built-in battery cool before

charging again.

• Always unplug the drone's battery when not in use.

Lithium Battery Notes

• Do not charge longer than recommended. Unplug the charging cable when

the battery is charged.

• Do not attempt to charge or operate damaged toys.

• Do not puncture or crush. Do not disassemble.

• Do not dispose of lithium batteries in the trash.

• If the electrolyte in the cells should get on your skin, thoroughly wash with soap

and water. If in the eyes, rinse thoroughly with cool water. Immediately seek

medical attention.

Install Batteries in the Remote Control

1. Make sure the remote control is turned o.

2. Use a screwdriver to open the battery compartment. Then insert four

AAA batteries (not included), matching

the polarities (+ and –) marked inside. Use

alkaline batteries for optimal performance.

Replace the cover.

Note: If the remote control’s LED ashes during

use, the batteries are low and should be replaced.

Battery Notes

• Dispose of old batteries promptly and

properly. Do not burn or bury them. Use

only fresh batteries of the required size and

recommended type.

• Do not mix old and new batteries, dierent types of batteries (standard,

alkaline, or rechargeable), or rechargeable batteries of dierent capacities.

• Remove batteries during longer storage periods. Batteries can leak

chemicals that can damage electronic parts.

6001436_UG_EN pre-inspection print.indd 5 8/26/2016 6:52:36 PM