User's Manual

Troubleshooting

Drone does not respond

• Make sure the drone and remote control are switched on and paired.

• The drone battery may be low. Fully charge the battery. See “Charge the

Drone Battery.“

• Remote control battery may be low. Replace the batteries. For app pilots,

recharge your smart device if the battery status is low.

• Make sure the drone is within the control range and in line of sight.

Drone difficult to control

• The propellers may be deformed due to a crash. Adjust deformed propellers by

hand. If you cannot adjust the propellers, replace with the spare propellers.

• The throttle control is very sensitive. Use small, ne movements to control.

• If you are a beginner, set to low speed, use the takeo and landing buttons

, and select headless mode.

Drone swerves or moves erratically before taking off

• After a crash, the gyroscope inside your drone may need calibrating. On the

remote control, do the following:

1. Switch on your drone and remote control, and pair them.

2. Move the throttle all the way down and the steering forward at the same

time. Hold this position until the drone LEDs start to blink rapidly. Then

release the controls.

3. The drone LEDs light steadily. Calibration is successfully

completed, and you are now ready for takeo.

• See “Trim Your Drone" to further ne tune and improve

control of your drone after calibration, if necessary.

• For app pilots, calibration is similar to the above. Move and

hold the app's onscreen throttle and steering controls for 3 seconds, and

then observe the drone LED status described in steps 2-3.

Need Spare Parts?

Need more spare propellers, or lost some of the accessories? Consult your

dealer for details on the 6001462 Crash Pack for 6001436 Accelerator.

6001436_UG_EN pre-inspection print.indd 15 8/26/2016 6:52:39 PM