User's Manual

Pairing

1. Turn on the drone. The LEDs on the drone ash.

2. Place the drone on level ground.

3. Turn on the remote control. The remote control's LED lights up.

4. Move the throttle all the way up and then down to pair the remote control

with the drone. The drone’s propellers remain still during pairing. When

paired, all LEDs on both the remote control and drone light steadily.

Note: If pairing fails, turn o the drone and remote control and repeat the steps

above, or change locations to avoid electrical interference.

Multiple Player Mode Pairing

You can play together with friends to y up to 6 Accelerators side by side.

Before pairing, make sure all players have switched o their Accelerators and

remotes. Players must pair their unit separately to avoid interference. Once

paired, keep your unit switched on, until the other players have also completed

pairing.

Fly Your Drone

1. There are 2 ways to take o. Place your drone on the ground and then either:

• Press the

button. The drone will automatically take o, ascending

about 5 ft (150cm) and then hover.

• Move the throttle forward to ascend. To avoid ground air turbulence, y

the drone at least 1 ft. (30cm) o the ground.

2. For speed options, push the steering control in to switch between high

speed (double beep) and low speed (single beep).

IMPORTANT: If your drone crashes upside down, pull the throttle all the way

down. Wait till the propellers have stopped still before you handle the drone.

Land Your Drone

Automatically: Press and the drone will steadily descend and land.

Manually: Slowly move the throttle backward to descend. Avoid moving the

throttle too quickly, as it can stop the propellers instantly and cause the drone to

crash.

• When you nish ying the drone, turn o the remote control and drone.

6001436_UG_EN pre-inspection print.indd 10 8/26/2016 6:52:37 PM