User's Manual

ManualsBrandsZEGO ELECTRONIC ManualsElectronicsCopter of Accelerator

14 15

Playback Photos/ Video

Accelerator photo and video shoots are stored in the app's 3 playback folders:

PICTURES, VIDEO and VIDEO Card.

• To playback, tap on the relevant folder to access content.

Note:

• For easy folder management, operate the camera either with the app

controls on your smart device, or with the remote control buttons.

• Remote control pilots: need to insert a SD card in the drone. Your media is

stored in the folder VIDEO Card.

• App pilots: there is no need to insert a SD card into the drone, unless you

like to use a SD card as backup. To view SD card content, the drone needs to

be switched on. Follow your device screen to access and view.

• For remote control pilots with smart device in holder: use your device

for instant playback. As well as shooting video and photos with your remote

control, you can also use the app's camera control buttons. In mixed control

mode shoots, app screen control shoots prioritize over remote control

shoots for storage.

Replace Damaged Propellers

The left and right propellers of the drone are

dierent (see A/B orientation marking on

propellers and on the rotor axles). You must use

the correct propeller in the correct location,

otherwise the drone will fail to take o.

WARNING:

• To avoid injury and damage, inspect the propellers for nicks and breaks and

make sure they are securely attached before and after each ight. Replace

nicked, chipped, cracked or broken propellers.

• Use only the supplied propellers. Do not alter, modify, or customize.

Troubleshooting

Drone does not respond

• Make sure the drone and remote control are switched on and paired.

• The drone battery may be low. Fully charge the battery. See “Charge the

Drone Battery.“

• Remote control battery may be low. Replace the batteries. For app pilots,

recharge your smart device if the battery status is low.

• Make sure the drone is within the control range and in line of sight.

Drone difficult to control

• The propellers may be deformed due to a crash. Adjust deformed propellers by

hand. If you cannot adjust the propellers, replace with the spare propellers.

• The throttle control is very sensitive. Use small, ne movements to control.

• If you are a beginner, set to low speed, use the takeo and landing buttons

, and select headless mode.

Drone swerves or moves erratically before taking off

• After a crash, the gyroscope inside your drone may need calibrating. On the

remote control, do the following:

1. Switch on your drone and remote control, and pair them.

2. Move the throttle all the way down and the steering forward at the same

time. Hold this position until the drone LEDs start to blink rapidly. Then

release the controls.

3. The drone LEDs light steadily. Calibration is successfully

completed, and you are now ready for takeo.

• See “Trim Your Drone" to further ne tune and improve

control of your drone after calibration, if necessary.

• For app pilots, calibration is similar to the above. Move and

hold the app's onscreen throttle and steering controls for 3 seconds, and

then observe the drone LED status described in steps 2-3.

Need Spare Parts?

Need more spare propellers, or lost some of the accessories? Consult your

dealer for details on the 6001462 Crash Pack for 6001436 Accelerator.

To replace a damaged propeller, use a screwdriver

to remove the old propeller. Insert a new matching

propeller onto the propeller axle, then screw

securely, but do not overtighten otherwise the

propeller won't turn.