User's Manual

4 5
3. To install the battery, plug the two ends of the
red battery connectors.They only t one way,
so do not use force. Neatly slot the battery and
cables into the drone's battery compartment.
CAUTION:
• After playing, let the built-in battery cool before
charging again.
• Always unplug the drone's battery when not in use.
Lithium Battery Notes
• Do not charge longer than recommended. Unplug the charging cable when
the battery is charged.
• Do not attempt to charge or operate damaged toys.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash with soap
and water. If in the eyes, rinse thoroughly with cool water. Immediately seek
medical attention.
Install Batteries in the Remote Control
1. Make sure the remote control is turned o.
2. Use a screwdriver to open the battery
compartment. Then insert four AAA
batteries (not included), matching the
polarities (+ and –) marked inside. Use
alkaline batteries for optimal performance.
Replace the cover.
Note: If the remote control’s LED ashes during
use, the batteries are low and should be replaced.
Battery Notes
• Dispose of old batteries promptly and properly. Do not burn or bury them.
Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, dierent types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of dierent capacities.
• Remove batteries during longer storage periods. Batteries can leak
chemicals that can damage electronic parts.
Specifications
Power ...............................................................................................................................................
Drone ........................................................ 3.7V, 2000mAh lithium polymer battery
Remote Control ................................................................................4 × AAA batteries
Control Distance .................................................................................... max. 190 ft. (58m)
App Distance .............................................................................................max. 130 ft (40m)
Camera ...........................................................................................................................................
Lens Resolution (video) .......................................................................1280 × 720 MP4
Photo Resolution ................................................................................1280 × 720 JPEG
Maximum SD card support ......................................................................................32G
Specications are subject to change and improvement without notice. Actual product
may vary from the images found in this document.
Fly Safely
• This drone is designed for outdoor play. However, the drone is neither
waterproof nor weatherproof. Do not play in rain, snow, or windy conditions.
• Do not y the drone near or at other people or animals.
• Do not y your drone where emergency responders are working, or
emergency aircraft are operating.
• Keep the drone away from power lines, trees, weeds, and water.
• Do not y your drone over private property where you are not welcomed.
• Keep eyes, hands, hair, and loose clothing away from moving propellers.
• Fly safely. If the drone crashes, the SD card may fall out.
• Adult supervision is recommended at all times.
Charge the Drone Battery
Make sure you use the supplied battery and AC adapter, or one of the same
type: 3.7 V, 2000mAh lithium polymer.
1. Connect the supplied AC adapter as shown below. The LED on the
adapter lights red during charging, and turns green when charging is
complete.
A full charge takes about 120 minutes. A fully charged battery provides up
to 10 minutes of ight and camera time.
2. After charging, unplug the adapter and separate the battery connectors.
Do not attempt to overcharge the battery.
LED
2 hr