Product specifications

Page 6
|
HDbridge 2312-EU Configuration Guide www.zeevee.com
Front Panel Conguration
You can set the RF broadcast channels using the
front panel controls. In many cases, your ZeeVee
modulator will require only these congurations.
Setting the RF broadcast channels or power
1. Unlock the panel by pressing/holding together
the left and right arrow buttons ( ) until
“Setup” lights up.
2. Press “OK” to enter the Conguration screen.
3. Use the arrow buttons ( ) to go to
each item you want to congure (such as RF
Number or RF Power), then press “OK” to edit
the highlighted eld. Use the up and down
() arrow buttons to scroll through the
options for that eld.
4. Once you’ve made changes, press “OK” to
accept. You can then select the next item for
conguration.
5. When nished making changes, use the
arrow buttons to scroll down and select
“Apply,” then click “OK” to save your changes.
Note: The front panel locks automatically after
a few seconds. To make more changes, press/
hold the left and right arrow buttons again to
re-enter the setup screen.
To update rmware:
• If unit is connected to the
internet and can communicate
with our servers, select Update
Firmware from the Setup screen
and press “OK”.
To reset IP address:
• When using DCHP, select Reset
IP Address to force a release/
renew of your IP address, and
press “OK”.
To restore factory defaults or
revert rmware:
1. Power down the unit.
2. Hold the left and right arrows
down and reapply power. You
will be prompted to a screen:
• Press up arrow to reset to
defaults;
• Press down arrow to revert
rmware.
Shows audio/video being
encoded
Green — Both audio and
video are detected
Yellow — Video, but no
audio detected
Red — No video detected
SETUP SCREEN
CONFIGURATION SCREEN
ACTIVE CONFIGURATION SCREEN