User`s manual
Quick Start Guide, document 96-00523-07 Page 4 of 5
GS8 Modular Gateway
• NAT Traversal Mode: Set to None unless the GS8 modular gateway and IP PBX are
located on the LAN behind a NAT router or firewall.
• MAX Connections: Use the default setting, but can be changed depending on your channel
(1-10).
6.10 Click Add.
6.11 Select Call Settings | Route.
6.12 Enter the routing table. The following is an example of routing all GSM calls to the IP port:
• Description: Enter a short description of the route, for example
GSM to IP.
• Source Line: Check All for GSM.
• Caller Pattern: Leave blank to default to all patterns.
• Callee Pattern: Leave blank to default to all patterns.
• Schedule: Set to Null for no time segment limitation, but you can program the times when
this rule applies if desired.
• Destination Line: Check 1 for IP.
6.13 Click Add.
6.14 In the same manner you can configure the way that calls are handled for IP to GSM for outgoing
calls. Depending on your requirements, you can also configure calls from GSM or CDMA to
FXO, FXO to GSM or CDMA, FXO to IP, and IP to FXO.
7 Configuring the SE30+, SE30P, SE150, SE500, or SE500X IP PBXs
After configuring the GS8 modular gateway, you need to ensure that your IP PBX is setup to receive calls
from the GS8 modular gateway. The following is an example of how you would set up your SE30+,
SE30P, SE150, SE500, or SE500X IP PBXs to make and receive calls from the GS8 modular gateway.
If you chose to use registered mode on the GS8 modular gateway, you only need to add an extension in the
Subscriber configuration of the IP PBX.
If you chose to use non-registered mode, you need to set the IP Trunk and configure a new Route to make
outgoing calls on the GS8 modular gateway.
7.1 Login to your SE30+, SE30P, SE150 or SE500 IP PBX.
7.2 Select Provision | Trunk | Trunk.
7.3 Trunk ID: Enter an unused two digit number greater than 32 for SE30+, SE30P, or SE150 IP PBX,
or greater than 64 for SE500 or SE500X IP PBX, for example 98.
7.4 Type: Set to IP.
7.5 Proxy Address: Enter the IP address and port number of the GS8 modular gateway, for example
192.168.1.100:5060.