User`s manual

Quick Start Guide, document 96-00523-07 Page 3 of 5
GS8 Modular Gateway
6 Setting the GS8 Modular Gateway to Work with your IP PBX
6.1 Login to the GS8 modular gateway.
6.2 From the Line Settings menu click on GSM Line, CDMA Line, or FXO Line depending on the
module to be configured.
6.3 Phone Number: Enter the phone number for that particular line.
6.4 Enable AA: Check the box if you intend to use the automated attendant (AA).
6.5 Output Volume / Input Volume: Set to Normal.
6.6 Voice In Call: Set to
Yes under normal volumes.
6.7 Working Frequency: For GSM modules only, set to the frequency bands used in your region.
6.8 Click Modify.
6.9 Select IP Line. There are two modes of operation for the GS8 modular gateway:
6.9.1 Registered mode: In this mode, the GS8 modular gateway registers with an IP PBX or IP soft-
switch similar to an IP phone. Enter the following data:
• Register: Set to
Enable.
• Proxy: Enter the IP address of the IP PBX.
• Register Server: Enter the IP address of the IP PBX.
• Phone Number: Enter the same number as on the IP PBX for this system.
• User name: Leave blank or enter the same name as on the IP PBX if connecting to an IP
PBX that requires authentication.
• Password: Leave blank or enter the same password as on the IP PBX if connecting to an IP
PBX that requires authentication.
• Register Expiration: Use the default setting, but can be changed to the desired expiration
time in seconds.
• Home Domain: Enter the home domain if required.
• NAT Traversal Mode: Set to None.
• MAX Connections: Use the default setting, but can be changed depending on your channel
(1-10).
• Enable AA: Set to
Enable if you intend to use the automated attendant (AA).
6.9.2 Non-registered mode: In this mode, the GS8 modular gateway does not register with an IP PBX
or IP soft-switch. It can operate in cluster mode.
• Register: Set to
Disable.
• Proxy: Enter the IP address of your IP PBX.