User`s manual

Quick Start Guide, document 96-00523-07 Page 2 of 5
GS8 Modular Gateway
3.1 You cannot login to the GS8 Administration UI if the PC IP address does not belong to the same
network segment as the GS8 modular gateway. We recommend temporarily changing the PC IP
address to the same network segment, for example 192.168.0.120, so you can login and setup the
IP address of the GS8 modular gateway as described in section 4. At that point you can change
the PC IP address back to its original setting.
3.2 On your PC, start the Internet Explorer web browser.
1
3.3 Enter http://192.168.0.100 in the address field.
3.4 Enter the user name and password to login. The default user name and password are admin.
4 Configuring the Network Settings
4.1 Select Administration | Network Setting.
4.2 Work Mode: To assign a fixed IP address to the GS8 modular gateway, set to
Static and enter
the IP Address, Net Mask, Default Gateway, and DNS settings obtained from your network
administrator for this system. Alternatively, select DHCP to allow the DHCP server to assign an
IP address.
4.3 Click Set. You may lose the network connection to the GS8 modular gateway after changing its
IP address; if so, change the PC IP address back to the original setting and login again to the GS8
modular gateway using its new IP address.
5 Upgrading the Firmware
5.1 Select Monitor | System Info.
5.2 Compare the firmware version listed on this page to the latest firmware version available for the
GS8 modular gateway on the Zed-3 Software web page. If both versions are the same, proceed to
Section 6.
5.3 If the firmware version on the web page is higher, download the firmware file to your PC.
5.4 Select Maintenance | Upgrade Firmware.
5.5 Click Browse, navigate to the downloaded firmware file on your PC, and select it.
5.6 Click Upgrade.
Warning Do not power down the PC or the GS8 modular gateway while upgrading the firm-
ware.
1. Firefox may also work but currently Zed-3 has not ensured compatibility.