Operation Manual

77
Printer Setup
Load the Media
11/5/15 P1048261-005
2. Rotate the printhead-open lever downward until it locks the printhead in place.
3. Set the printer to Tear-Off mode (for more information, see Print Mode on page 97).
4. Close the media door.
5. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
6. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 122.
7. If desired, perform the CANCEL Self Test on page 165 to verify that your printer is able to
print.
Media loading in Tear-Off mode is complete.