Operation Manual

Printer Setup
Load the Media
70
P1048261-005 11/5/15
Load the Media
Use the instructions in this section for loading roll or fanfold media in any print mode.
To load media, complete these steps:
1. Raise the media door.
2.
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Open the printhead assembly by rotating the printhead-open lever.