Operation Manual

Printer Setup and Operation

Install the Printer Driver and Connect the Printer to the Computer—Wireless

P1048261-005 ZT200 Series™ User Guide 11/5/15

Connect the Printer to Your Wireless Network

If you wish to use the printer’s optional wireless print server, you must first connect the printer

to your computer using one of the other available connections. While the printer is connected

via one of those connections, you configure the printer to communicate with your Wireless

Local Area Network (WLAN) through the wireless print server.

For additional information about Zebra print servers, refer to the ZebraNet

Wired and Wireless Print Server User Guide. To download the latest version

of this guide, go to http://www.zebra.com/zt400-info.

To connect the printer to your computer by an optional wireless print server,

complete these steps:

1. Install Zebra Setup Utilities as instructed in Install Zebra Setup Utilities on page 28.

2. Connect the printer to your computer using a USB, serial, or optional parallel port as

instructed in Connect a Computer to the Printer’s USB Port on page 37 or Connect a

Computer to the Printer’s Serial or Parallel Port on page 41.

3. Configure the following printer settings. You can change the values through the Zebra

Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)

or by the ways listed at the following links. Contact your network administrator for the

proper values for your network.

• IP Protocol on page 111 (change the value from ALL to PERMANENT)

• Gateway on page 110 (match the gateway value of your WLAN)

• Subnet Mask on page 109 (match the subnet value of your WLAN)

• IP Address on page 109 (assign a unique IP address to the printer)