Operation Manual

Printer Setup and Operation

Install the Printer Driver and Connect the Printer to the Computer—Ethernet

P1048261-005 ZT200 Series™ User Guide 11/5/15

Configuring the printer with your LAN information (if necessary)

If your printer connected to your network automatically, you do not need to complete this

section. Continue with Adding a Printer from the Zebra Setup Utilities Screen on page 51.

4. Connect the printer to your computer using a USB, serial, or optional parallel port as

instructed in Connect a Computer to the Printer’s USB Port on page 37 or Connect a

Computer to the Printer’s Serial or Parallel Port on page 41.

5. Configure the following printer settings. You can change the values through the Zebra

Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)

or by the ways listed at the following links. Contact your network administrator for the

proper values for your network.

• IP Protocol on page 111 (change the value from ALL to PERMANENT)

• Gateway on page 110 (match the gateway value of your LAN)

• Subnet Mask on page 109 (match the subnet value of your LAN)

• IP Address on page 109 (assign a unique IP address to the printer)