Operation Manual

139
Routine Maintenance
Cleaning Schedule and Procedures
11/5/15 P1048261-005
6. Reload the ribbon (if used) and the media. For instructions, see Load the Ribbon
on page 65 or Load the Media on page 70.
7. Rotate the printhead-open lever downward until it locks the printhead in place.
8. Close the media door.
The printer is ready to operate.
9. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
Note • If performing this procedure does not improve print quality, try cleaning the
printhead with Save-A-Printhead cleaning film. This specially coated material removes
contamination buildup without damaging the printhead. Call your authorized Zebra
reseller for more information.