Operation Manual

105
Printer Configuration and Adjustment
Changing Printer Settings
11/5/15 P1048261-005
MEDIA/RIBBON CAL
Media and
Ribbon Sensor
Calibration
Calibrate the printer to adjust the sensitivity of the media and ribbon sensors.
For complete instructions on how to perform a calibration procedure, see Calibrate the
Ribbon and Media Sensors on page 122.
User menu item:
Main Menu >
TOOLS
Main Menu >
SENSORS
Related ZPL command(s):
~JC
SGD command used:
ezpl.manual_calibration
Control panel key(s):
Hold
PAUSE + CANCEL for 2 seconds to initiate
calibration.
Printer web page:
The calibration procedure cannot be initiated through the
web pages. See the following web page for settings that
are set during sensor calibration:
View and Modify Printer Settings > Calibration
Important • Do not change these settings unless
you are told to do so by Zebra Technical Support
or by an authorized service technician.
Table 6 • Calibration and Diagnostic Tools (Continued)