Operation Manual

123
Printer Configuration and Adjustment
Calibrate the Ribbon and Media Sensors
11/5/15 P1048261-005
The printer does the following:
•The STATUS light and SUPPLIES light flash yellow once.
•The PAUSE light blinks yellow.
• The control panel (ZT230 printer only) displays:
2.
3.
Extend the media approximately 8 in. (203 mm) out of the printer.
MEDIA/RIBBON CAL
LOAD BACKING
REMOVE RIBBON
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Open the printhead assembly by rotating the printhead-open lever.