Operation Manual

119
Printer Configuration and Adjustment
Changing Printer Settings
11/5/15 P1048261-005
TAKE LABEL
Take Label Set the intensity of the take label LED.
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
User menu item:
Main Menu >
SENSORS
Accepted values:
0 – 255
SGD command used:
ezpl.take_label
Printer web page: View and Modify Printer Settings > Calibration
Table 9 • Sensor Settings (Continued)