User Manual

ZQ630 User Guide

Icon Status Indication

Blinking red

Error exists (excluding Media Out

and Head Latch Open)

Not Present No error exists

4 green bars 802.11 signal strength > 75%

3 green bars 802.11 signal strength </= 75%

2 green bars

802.11 signal strength </= 50%

but >25%

1 yellow bar 802.11 signal strength </= 25%

0 Bars No Signal Strength

Troubleshooting Topics

1. No power:

• Check that battery is installed properly.

• Recharge or replace battery as necessary.

Caution • Always dispose of batteries properly. Refer to Appendix F

for more information on proper battery disposal.

2. Media does not feed:

• Be sure media cover is closed and latched.

• Check spindle holding media for any binding.

• Ensure most recently printed label is removed (only in peel

mode).

• Ensure label sensor is not blocked.

3. Poor or faded print:

• Clean print head.

• Check quality of media.

4. Partial or missing print:

• Check media alignment.

• Clean print head.

• Ensure media cover is properly closed and latched.

5. Garbled print:

• Check baud rate.