User Manual

61
ZQ630 User Guide
1. Undo the snap on the Waist Strap
which helps attach it to the printer
Mount Pad.
2. Unlock the male D swivel clip (cir-
cled) on the Waist Strap from the fe-
male D clip on the printer Mount Pad to
remove.
3. Align the holes on the Mount
Pad with the mounting holes on the
bottom of the printer (circled). Use
a 4mm hex driver on the two 6-32 x
0.375” screws (green circle) and two
#6 washers to attach the Mount Pad
to the top of the printer. Attach the
two (2) 6-32 x 0.625” screws (red cir-
cle) and washers on the bottom of the
Mount Pad.
4. Connect the male D swivel clip
on the Waist Strap to the female D
clip on the printer Mount Pad. Snap
shut to secure (opposite side) and
rotate the Waist Strap 180
o
.
5. Unsnap the Waist Strap and
adust the strap to the desired length.
6. Wrap the Waist Strap around
your waist and snap the clip in place
to secure. The printer should hang
comfortably below the hip.
Waist Holster
ZQ630 printer has a waist holster option (p/n SG-MPP-Q4HLSTR1-01)
that allows the user to carry the printer around their waist for easy
access.