User Manual

60
ZQ630 User Guide
Hard Case
ZQ630 printer has a two piece hard case option (P1050667-034)
that also allows you to carry the printer from your belt with the metal
belt clip (included), while also providing increased protection for the
printer. It pivots via a hinge located on the back and snaps into place
in front as shown below. The metal belt clip is mounted to the hard
case and printer with two screws. If no belt clip is used, two shorter
screws are used to hold the printer to the hard case.
Figure 39 • Using the Hard Case
1. Insert the printer into the
bottom half of the Hard Case
shell.
2. Rotate the top half of the
Hard Case shell over the top
of the printer and snap shut.
3. Use a #1 Phillips Head
driver to secure the two (2)
6-32 x 5/8 screws to the
bottom of the Hard Case.