User Manual

44
ZQ630 User Guide
The other end of the cable must be plugged into the host terminal
as shown in Figure 18, or to a serial or USB port on a computer.
The ZQ630 printer is congured with the USB Open HCI interface
driver allowing it to communicate with Windows
®
based devices.
Zebra Designer Driver uses Windows drivers that support
printing via Serial, USB and the network. Other terminals or
communications devices may require the installation of special
drivers to use the USB connection. Consult the factory for further
details.
Providing Strain Relief for Communications Cable
If you are connecting either a USB or RS-232 communications
cable to the printer permanently, access the communications port
on the side of the printer next to the latch release lever. Plug the
connector into the appropriate port and align the plastic locking cap
with the cut outs shown below. Rotate the locking cap clockwise
to lock the cable in place. (Turn counter clockwise to unlock the
cable.) Once locked in place, this provides strain relief for the cable
and will prevent the cable from disconnecting from the printer.
Note • Only one cable can be present in the USB/RS-232
communications port at a time for strain relief purposes.
1. Insert connector in
communications port.
2. Rotate locking cap
clockwise to secure.