User Manual
41
ZQ630 User Guide
When the printer is in sleep mode, the green LED ring around the
power button will pulse approximately once every three seconds.
Pressing any button on the printer will wake the printer from sleep
mode. Other power mangement features of the ZQ630 printer
include “wake on Bluetooth” and “wake on WiFi” whereby the
printer exits sleep mode due to data exchanged via Bluetooth 4.1
or a network message received over WiFi. The printer will not enter
sleep mode when docked in an Ethernet cradle.
To enable or disable Sleep Mode, send the power.sleep.enable
command to the printer using Zebra Setup Utilities (ZSU) and
set it to either “on” or “o”. (The default setting is “on”.) To set
the time after which the printer will enter Sleep Mode, send the
power.sleep.timeout (in seconds) to the printer using the ZSU.
Adaptive Print Performance
The ZQ630 printer uses PSPT PrintSmart Gen 2 technology
which adapts to your print conditions such that print quality is not
sacriced. When the printer sees environmental conditions such as
state of charge, battery health, cold temperature extremes, or high
density printing, the printer will adjust print performance to preserve
battery function and allow printing to continue. This may aect the
speed and sound of printing but not the print quality.
Draft Mode
The user can congure the printer to print in Draft Mode via
SGD command media.draft_mode (default is “o”), which
optimizes the printer for text-only printing. While in Draft Mode,
print speed increases from 4 inches per second (ips) to 5 ips with
approximately a 22% reduction in optical density.
Note • For an explanation and a list of all SGD commands,
please refer to the Programming Guide (p/n P1012728-010) at:
http://www.zebra.com/us/en/support-downloads.html