User Manual

ZQ630 User Guide

Loading Media in Peel-o󰀨 Mode

• If you plan to use the printer in the peel-o󰀨 mode, peel a

few labels o󰀨 of the media and load the media as previously

described.

• Press down on the latch release lever to open the media cover

and load the media as shown in Figures 7 and 8.

• Close the media cover as shown in (1) in Figure 9.

• Push the peeler lever up (2) and lock it in place to release the

peeler bail into the “up” position (3).

• The media will feed between the peeler bail and platen.

Figure 9 • Activating Peeler Bar

• Turn on the printer or press the Feed button on the front of the

printer if the printer is already on. The printer will advance the

media to the next label, if printing labels. If you are printing on

journal media, the printer will advance a short strip of media.

To disengage the peeler bail, press the button on the peeler lever

and press down on the peeler button to lock it in place in its original

home position.