Installation guide

P1073631-001 pg. 11

pg. 10 P1073631-001

Printer Removal

Remove the printer from the BE Cradle by following the steps below:

1. Push the Eject Button (Step 1) on the back of the cradle in the direction shown below.

2. Pivot the printer up and out of the cradle (Step 2).

Figure 5: un-Docking tHe Printer

Operational Notes

The media compartment and operator controls can be reached while the printer is secured to the

cradle.

If you need to take out the printer, follow the removal procedure detailed above in the Printer

Installation and Removal section.

If using a printer that has a Bluetooth or 802.11 radio, that radio can be used while the printer is

docked.

The USB ports on the printer can be used while the printer is docked.

The DC input barrel jack connection on the printer can NOT be used while the printer is in the cradle.

Using the Printer on the BE Cradle

Prepare the printer for docking onto the Battery Eliminator Cradle by doing the following:

• Remove the battery from the printer.

• Use a coin or small screwdriver to remove the plastic Docking Contacts Cover on the

bottom of the printer (as shown).

XXXXXXXXXXXX

• If necessary, clean any residue from the docking contacts using a Zebra cleaning pen or

a cotton swab with 70% Isopropyl alcohol.

• Angle the front of the printer toward the two (2) guide prongs on the front of the cradle

as shown in Step 1 below.

• Gently slide the printer onto the cradle mating the Battery Connector and Docking

Connector on the cradle with the corresponding connectors on the printer (Step 2).

• Press the printer down and onto the cradle until the latches lock it firmly in place (Step

3).

Figure 4: Docking tHe Printer on tHe Be craDle

• Verify that the charge LED indicator on the front of the printer and power indicator LED

(Fig. 1) on the cradle’s panel are lit.

• The printer will turn on automatically when docked if the cradle is powered on.