Installation guide

P1073631-001 pg. 5

pg. 4 P1073631-001

No Liability for Consequential Damage

In no event shall Zebra Technologies Corporation or anyone else involved in the creation,

production, or delivery of the accompanying product (including hardware and software) be liable

for any damages whatsoever (including, without limitation, damages for loss of business profits,

business interruption, loss of business information, or other pecuniary loss) arising out of the use of

or the results of use of or inability to use such product, even if Zebra Technologies Corporation has

been advised of the possibility of such

damages. Because some states do not allow the exclusion of liability for consequential or incidental

damages, the above limitation may not apply to you.

Copyrights

The copyrights in this manual and the label print engine described therein are owned by Zebra

Technologies Corporation. Unauthorized reproduction of this manual or the software in the label

print engine may result in imprisonment of up to one year and fines of up to $10,000 (17 U.S.C.506).

ZebraLink and all product names and numbers are trademarks, and Zebra, the Zebra logo, ZPL, ZPL II, Element

All other brand names, product names, or trademarks belong to their respective holders.

Special Notices

The following notices emphasize certain information in the guide. Each serves a special purpose

and is displayed in the format shown:

Note: Note is used to emphasize any significant information.

Caution: Indicates information that, if not followed, can result in damage to software, hardware, or

data.

Warning: This warning symbol indicates an imminently hazardous situation which, if not avoided will

result in death or serious injury. Before you work on any equipment, be aware of the hazards involved

with electrical circuitry and be familiar with standard practices for preventing accidents

General Warnings and Cautions

Caution: Read the following installation instructions before you connect the system to its power source.

Note: Zebra Technologies Corporation is not liable for personal injury or damage to any equipment

caused by the improper installation of this equipment to any power source.

Vehicle Installation Safety

Caution: Only trained and qualified personnel should be allowed to install, replace, or service this

equipment.

Caution: DO NOT USE THE PRINTER WHILE DRIVING, as this may result in property damage or personal

injury. Zebra Technologies Corporation. does not promote the use of these products except when parked

or stationary, and is not responsible for any loss resulting from the use or misuse of our products.

Caution: Do not install the Battery Eliminator Cradle where it will be exposed to precipitation, extreme

temperatures or excessive condensation.

Caution: Do not install the Battery Eliminator Cradle in a location that will affect vehicle safety or

drivability.

Caution • Use only the approved power supply for the Battery Eliminator Cradle. Use of an alternative

power supply will void the product warranty and may cause product damage.