Installation guide

P1071266-001 pg. 11
pg. 10 P1071266-001
• If necessary, clean any residue from the docking contacts using a Zebra cleaning pen or a cotton swab with
70% Isopropyl alcohol.
• Angle the front of the printer toward the two (2) guide prongs on the front of the Power Station as shown in
Step 1 below. Gently slide the printer onto the Power Station.
• Press the printer down and onto the Power Station until the latches lock it firmly in place (Step 2).
Figure 5: Power Adapter 1
Figure 6: Power Adapter 2
Figure 7: Docking Cover
Figure 8: Printer Docking
Power Adapter Orientation
+M
XXXXXXXXXXXX
+M
XXXXXXXXXXXX
Using the Printer on the Power Station
Prepare the printer for docking onto the Power Station by doing the following:
• Remove the battery from the printer.
• Use a coin or small screwdriver to remove the plastic Docking Contacts Cover on the bottom
of the printer.
• Re-install the battery.
The power adapter can attach to the Power Station in two different ways.
Option 1
1. Insert the Power Adapter into the well at the top of the Power Station.
2. Connect the DC Input where indicated below.
3. Run the AC cable through the opening on the opposite end of the well.
Option 2
1. Lay the Power Adapter in the well at the bottom of the Power Station where shown
below.
2. Attach two (2) velcro straps to the plastic posts to secure the Power Adapter to the base.
3. Connect the DC Input where indicated below.
4. Run the AC cable beneath the cable clip (where shown) to secure.
Note • The Power Adapter can also be positioned in the opposite well at the bottom of
the Power Station.
DC Input
Power Adapter
Power Adapter
Velcro Straps Cable Clip
DC Input