Installation guide

P1071266-001 pg. 9
pg. 8 P1071266-001
Introduction
The ZQ500 4-Bay Power Station allows a total of four (4) ZQ510 or ZQ520 printers to be docked
and charged. The Power Station provides battery charging power while still maintaining all of the
printer’s functionality.
The Power Station has one input connection:
• A DC power supply input connects to the supplied AC/DC power adapter.
The following instructions detail the installation and use of the 4-Bay Power Station. Following these
instructions closely will ensure safe and reliable performance of the printer when docked on the Power Station.
The user should always refer to the ZQ500 Series Users Guide (p/n P1064404-001) for complete information on
using the printer.
In the Americas contact:
Zebra Technologies Corporation
475 Half Day Road, Suite 500
Lincolnshire, IL 60069 USA
T: +1 847.634.6700 or +1 800.423.0442
In Europe, Africa, the Middle East, and India contact:
Zebra Technologies Europe Limited
Dukes Meadow, Millboard Road
Bourne End
Buckinghamshire SL8 5XF, UK
T: [phone]
F: [phone]
120 Robinson Road
#06-01 Parakou Buildin g
Singapore 068913
T: [phone]
F: [phone]
Zebra Technologies Corporation
475 Half Day Road, Suite 500
Lincolnshire, IL 60069 USA
T: +1 847.634.6700 or +1 800.423.0442
AA18153-104 Rev. B
August 2012
AA18153-104
Installation
The ZQ500 4-Bay Power Station allows you to dock total of four (4) ZQ500 Series printers.
The installation of the Power Station includes a supplied AC/DC power adapter
(p/n P1026943-1) , which provides power to run the printers and charge their batteries.
Note • Hardware used to secure the Power Station to the desktop and wall is not supplied in the
installation kits.
Note • It is important to leave a free zone around the printer to allow the loading of media.
Required for Installation
• An electric drill with a 1/4” (6 mm) drill bit
• Common hand tools
• Wood screws
Option 1
When attaching the 4-Bay Power Station on the desktop or shelf, use the four (4) through
holes circled below:
Option 2
When attaching the Power Station to a wall:
1. Locate wall studs in the mounting area.
2. Drill three (3) holes using the through holes circled below (View 1).
3. Drill three (3) additional holes using the guides on the rear base of the unit circled below (View 2).
4. Use hardware listed above to secure to the wall.
View 1
View 2
Figure 2: Packaging Contents
Figure 3: Desktop Mounting
Figure 4: Wall Mounting