ZQ500 Series 4-Bay Power Station Installation Guide © 2014, ZIH Corp.
Contents Proprietary Statements Product Improvements..................................................................3 FCC Compliance Statement...........................................................3 Canadian Compliance Statement...................................................3 Agency Approvals and Regulatory Information..............................3 Liability Disclaimer.........................................................................4 No Liability for Consequential Damage................
Liability Disclaimer In as much as every effort has been made to supply accurate information in this manual, Zebra Technologies Corporation is not liable for any erroneous information or omissions. Zebra Technologies Corporation reserves the right to correct any such errors and disclaims liability resulting therefrom.
Indicator and Parts Descriptions Installation Safety Caution • Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 3 Top View Warning • It is very important to ensure that the correct power adapter is connected to the cradle. 1 Note • Zebra Technologies Corporation is not liable for personal injury or damage to any equipment caused by the improper installation of this equipment to any power source.
Required for Installation Figure 2: Packaging Contents • • • An electric drill with a 1/4” (6 mm) drill bit Common hand tools Wood screws Option 1 When attaching the 4-Bay Power Station on the desktop or shelf, use the four (4) through holes circled below: Zebra Technologies Corporation Figure 3: Desktop Mounting 475 Half Day Road, Suite 500 Lincolnshire, IL 60069 USA T: +1 847.634.6700 or +1 800.423.
Using the Printer on the Power Station Power Adapter Orientation Prepare the printer for docking onto the Power Station by doing the following: The power adapter can attach to the Power Station in two different ways. Option 1 1. Insert the Power Adapter into the well at the top of the Power Station. 2. Connect the DC Input where indicated below. 3. Run the AC cable through the opening on the opposite end of the well. DC Input • • • Remove the battery from the printer.
• • Verify that the charge LED indicator on the front of the printer and power indicator LED (Figure 1 #2) on the Power Station’s panel are lit. Turn the printer on and print a configuration label to verify that the printer is functioning properly. Refer to the ZQ500 Series User Guide for instructions on printing a configuration label. Note • A printer using an extended battery or exoskeleton can still be docked on the Power Station. However, a printer housed in a soft case cannot.
Appendix A: Technical Specifications Technical Support U.S. Only Physical • Height: 80 mm (3.14 in.) • Length: 702 mm (27.6 in.) • Width: 171 mm (6.73 in.) • Weight (cradle only): 2.6 kg (5.73 lb.) Zebra maintains a help line for questions involving installation and use of the 4-Bay Power Station. Please have as much information as possible regarding your particular application ready when you call to enable the technical support personnel to help you. The number in the U.S.
pg.
