User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ300 Series
- Unpacking and Inspection
- Reporting Damage
- Features Overview
- Getting Ready to Print
- Battery
- Installing/Removing Battery & Battery Tape Insulator
- Battery Tape Insulator
- Battery Safety
- Charger Safety
- Designing Labels
- Using Pre-Printed Receipt Media
- Loading the Media
- Media Spacers
- Operator Controls
- Forced Download Description and LED Behavior
- Power Save Mode
- Draft Mode
- Verify the Printer Is Working
- Cable Communication
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- NFC Use Cases
- WLAN Overview
- Setting Up the Software
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- ZQ300 Series Cleaning
- Troubleshooting
- Printer Status Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Report
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications
- Media Specifications
- ZPL Bar Code Specifications and Commands
- CPCL and ZPL Font Specifications
- Printing in Chinese Fonts
- USB Type-C to Type-A Communications Cable
- Physical, Environmental and Electrical Specifications
- ZQ300 Series Accessories
- Appendix A
- Serial Number and PCC Number Locations
- Appendix B
- User Interface LED Charging Behavior
- Appendix C
- Battery Disposal
- Product Disposal
- Appendix D
- Appendix E
- Using Zebra.com
- Product Support Contacts
- Index
69
ZQ300 Series User Guide
continued
Figure 28 • USB Type-C to Type-A Pinouts
A1
A12
B1
B12
Pin 1
Pin 4
Type-C Type-A
USB Type-C to Type-A Communications Cable
Type-C Plug Wire Type-A Plug
Pin
#
Signal
Name
Wire
#
Signal
Name
Pin
#
Signal
Name
A1,B1,
A12,B12
GND 1 GND_PWrt1 4 GND
A4,B4,A9,
B9
VBUS 2 PWR_VBUS1 1 VBUS
A5 CC See Note 1
B5 VCONN -
A6 Dp1 3 UTP_Dp 3 D+
A7 Dn1 4 UTP_Dn 2 D-
Shield Braid Shield Shell Shield
Notes:
1. Pin A5 (CC) of the USB Type-C plug shall be connected to VBUS through a
resistor Rp(56 kΩ+/- 5%).
2. Contacts B6 and B7 should not be present in the USB Type-C plug.
3. All VBUS pins shall be connected
together within the USB Type-C plug.
Bypass capacitors are not required for
the VBUS pins in this cable.
4. All Ground return pins shall be
connected together within the USB Type-C plug.
5. All
USB Type-
C plug pins that are not listed in this table shall be open (not connected).