User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ300 Series
- Unpacking and Inspection
- Reporting Damage
- Features Overview
- Getting Ready to Print
- Battery
- Installing/Removing Battery & Battery Tape Insulator
- Battery Tape Insulator
- Battery Safety
- Charger Safety
- Designing Labels
- Using Pre-Printed Receipt Media
- Loading the Media
- Media Spacers
- Operator Controls
- Forced Download Description and LED Behavior
- Power Save Mode
- Draft Mode
- Verify the Printer Is Working
- Cable Communication
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- NFC Use Cases
- WLAN Overview
- Setting Up the Software
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- ZQ300 Series Cleaning
- Troubleshooting
- Printer Status Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Report
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications
- Media Specifications
- ZPL Bar Code Specifications and Commands
- CPCL and ZPL Font Specifications
- Printing in Chinese Fonts
- USB Type-C to Type-A Communications Cable
- Physical, Environmental and Electrical Specifications
- ZQ300 Series Accessories
- Appendix A
- Serial Number and PCC Number Locations
- Appendix B
- User Interface LED Charging Behavior
- Appendix C
- Battery Disposal
- Product Disposal
- Appendix D
- Appendix E
- Using Zebra.com
- Product Support Contacts
- Index
50
ZQ300 Series User Guide
Wearing the Printer
Belt Clip
All ZQ300 Series printers have a belt clip shipped with the print-
er as a standard feature. The steps used to install the belt clip on
the printer are illustrated below. Once the belt clip is hooked over
your belt in a secure fashion, the belt clip will enable the printer to
pivot easily to allow for freedom of movement while either stand-
ing or sitting.
continued
Figure 24 • Belt Clip Installation
The viewing area of the printer’s faceplate (which displays bat-
tery life, Bluetooth, Wi and the error icons), is angled such that
it can be seen from above while the printer hangs from the belt
clip (as shown below).
1. 2.
3.
4.