User Manual

38
ZQ300 Series User Guide
Printing a Conguration Report
1. Press and hold the Feed Button.
2. Press and hold the Power Button until the Power LED blinks
(1/4 second).
3. Release the Power Button.
4. The Fault LED will start to pulse.
5. Continue to hold the Feed Button until the WiFi LED lights
up Amber.
6. Release the Feed Button and the WiFi LED will turn off and
the Fault LED will stop pulsing.
7. The printer will print the Zebra logo and “Building Two-Key
Report”.
8. The printer will then print the Conguration Report.
Sleep Mode
The Sleep Mode feature is a way the printer conserves battery
life whereby the printer will automatically go into a “sleep” state
after twenty (20) minutes of inactivity. The printer indicates Sleep
Mode when the Power LED Ring pulses (see Page 34).
If the Power Button is pressed for less than three (3) seconds,
then the printer will enter Sleep Mode.
If the Power Button is pressed for more than three (3) seconds,
then the printer will power down completely.
In order to “wake up” the printer, the user must press the Power
Button for less than three (3) seconds.
To enable or disable Sleep Mode, send the p ow er.sle ep.en-
able command to the printer using Zebra Setup Utilities (ZSU)
and set it to either “on” or “off”. (The default setting is “on”.) To set
the time after which the printer will enter Sleep Mode, send the
p ow er.sle ep.ti m eo ut (in seconds) to the printer using the
ZSU.
Note • If using a Bluetooth-only printer, it will wake up on its own
when communication is initiated via Bluetooth.