User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ300 Series
- Unpacking and Inspection
- Reporting Damage
- Features Overview
- Getting Ready to Print
- Battery
- Installing/Removing Battery & Battery Tape Insulator
- Battery Tape Insulator
- Battery Safety
- Charger Safety
- Designing Labels
- Using Pre-Printed Receipt Media
- Loading the Media
- Media Spacers
- Operator Controls
- Forced Download Description and LED Behavior
- Power Save Mode
- Draft Mode
- Verify the Printer Is Working
- Cable Communication
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- NFC Use Cases
- WLAN Overview
- Setting Up the Software
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- ZQ300 Series Cleaning
- Troubleshooting
- Printer Status Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Report
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications
- Media Specifications
- ZPL Bar Code Specifications and Commands
- CPCL and ZPL Font Specifications
- Printing in Chinese Fonts
- USB Type-C to Type-A Communications Cable
- Physical, Environmental and Electrical Specifications
- ZQ300 Series Accessories
- Appendix A
- Serial Number and PCC Number Locations
- Appendix B
- User Interface LED Charging Behavior
- Appendix C
- Battery Disposal
- Product Disposal
- Appendix D
- Appendix E
- Using Zebra.com
- Product Support Contacts
- Index
33
ZQ300 Series User Guide
Normal Boot-up LED Behavior
1. Press Power (on/off) button and all LED indicators will illumi-
nate until the button is released.
2. When Power button is released, the Fault LED will be
steadily lit and the power ring will blink.
3. When the boot-up sequence is complete, the power ring will
stop blinking and remain steadily lit. The color of the power ring
depends on the charge status.
4. All other LED’s (Fault, Battery, WiFi, Bluetooth) will reect
the current state of the printer.
Note • If you press the Power Button for more than ve (5)
seconds, the boot-up sequence will be aborted and all LED’s
will turn off.
Sleep Mode LED Behavior
1. During Sleep Mode, the Power LED will slowly pulse either
Green, Amber or Red depending upon whether or not the printer
is charging successfully.
2. All other LED’s will be shut off while in sleep mode.
Shutdown Behavior
1. Press the Power Button for approximately three (3) seconds
until the Fault LED turns on and the Power Ring starts blinking.
3. All LED’s will turn off when the shutdown process is com-
plete.
Firmware Download Behavior
The WiFi LED will alternately blink yellow and green while the
printer is either in forced download mode or if the printer is pro-
cessing a rmware download.