User Manual

31
ZQ300 Series User Guide
Media Spacers
Zebra provides a media spacers kit (p/n KIT-MPM-
MDSPR5-01) that allows the ZQ320 printer to support 3 in. (76.2
mm) and the ZQ310 to support 2 in. (50.8 mm) wide media.
1. The media spacers slide into the media compartment in the
circled areas below.
2. Slide the prongs on the back of the spacer into the grooves
on each side of the media compartment (circled).
3. Use a at head tool to insert in the slot at the top of the
spacer (circled) to pull up and remove.