User Manual

Table Of Contents

ZQ300 Series User Guide

Note • Black bars are located on the back of the media and are

only shown in the above view for illustration purposes.

Black Mark Dimensions (Receipt Media)

The reective media black marks (or black bar/marks) should

extend past the centerline of the roll on the front side of the pa-

per.

• Minimum mark width: 0.59 in. (15 mm) perpendicular to the

edge of the media, and centered within the width of the

roll.

• Mark length: 0.19 - 0.24 in. (4.8 - 6.0 mm) parallel to the

edge of the media.

Safe Printing Zone

1.59 mm1.59 mm

1.25 mm

“H”

Max Label Height = “H” = 2.5 mm

CPCL Label

Height

Media Feed Direction

Safe Printing Zone

Black Bar

Figure 14 • Black Bar Label Media

Using Pre-Printed Receipt Media

ZQ300 Series printers support alignment of pre-printed re-

ceipts by using the out of paper sensor located near the

printhead.